DIMMER LED 2-100VA

Low-profile LED dimmer. Different colored Impressivo center plates are ordered separately. The recessed depth of the LED dimmer is 20 mm. The dimmer features an N-terminal for connecting the neutral wire. In some cases, compatibility issues may arise between LED lights and the dimmer. These issues are typically resolved when the neutral wire is also connected to the dimmer. Note! The neutral wire is not mandatory—the dimmer also operates as a 2-wire version! The LED rotary dimmer is a 2-wire solution (no neutral wire required). The dimmer can be set to either RL or RC operation. The dimmer's power range is 2-100 VA for LED loads. 10-360 W for other loads (see installation instructions). With traditional transformers, approximately 20% power loss must be accounted for. With electronic transformers, approximately 5% power loss must be accounted for. Linear and quiet dimming is possible thanks to the MOSFET transistor. Permitted loads: Dimmable retrofit (E27, E14, GU10) LED, 230 V. Halogen lamps, 230 V. Dimmable retrofit (GU5.3) LED, 12 V (transformer L, LC). Halogen lamps, 12 V (transformer L, LC). Dimmable energy-saving lamps. Incandescent lamps, 230 V. Mixed loads are permitted. Electronic short-circuit and overload protection. The dimmer's base brightness can be adjusted by turning the potentiometer located in the upper right corner of the device (min setting). Operation in switching circuits is possible according to the installation instructions. This product description is an automated translation of the original Finnish description.