MOTION DETECTOR EER505 360D 10A IP41 FM WHITE

The motion sensor automatically controls lighting on and off in long corridor and entrance areas based on light level and movement. It can be used in master-slave configurations to extend the detection area, with up to 10 sensors connectable as slaves.

Automatic and semi-automatic operating modes can be activated using a dedicated remote control. The detection area at an installation height of 3 m is approximately 30 x 5 m for transverse movement and approximately 14 x 5 m for directional movement. The detection area can be restricted using masking tapes supplied with the sensor. The lighting off delay can be set between 5 s and 60 min. Alternatively, the sensor can be used for pulse-type control when movement is detected.

Installation is into the ceiling, recessed into the ceiling surface, with a mounting hole diameter of 68 mm. The sensor is equipped with a 0-point relay contact with a maximum LED lamp switching capacity of 400 W (20 x 20 W).

This product description is an automated translation of the original Finnish description.