LED STRIP RIBBONCOM 3K 4M IP44

Efficient, cuttable LED strip with LEDs placed very close together (192 LEDs/m). This strip is used not only for kitchen task lighting but also as indirect lighting behind mirrors, in skirting boards, furniture, ceilings, and anywhere a light source needs to be nearly invisible. Especially when installed in the LIMENTE LIGHTING BAR, the light is pleasantly uniform and even. Standard LEDs with a color rendering index of CRI>85, efficiency of 115 lm/W, luminous flux of 1380 lm/m, and color temperature of 3000 K are used (small variations in color temperature may occur between production batches). For IP44 models, length options are 2 m and 4 m. Both ends of the strip come standard with a 5 cm + 300 cm cable. If this is insufficient, you can order an extension cable (3 m), product number 681588. A maximum of one extension cable can be connected per light’s cable, allowing a maximum total cable length of up to five meters. The power supply cable on both ends enables the RIBBON to be utilized in two separate sections, thus avoiding unnecessary waste and allowing installation from the power source in two different directions. The RIBBON strip must be used with a compatible 24 V power supply. Suitable options are listed with the products. If the pre-assembled set does not suit your application, you can also order the profile, LED strip, and power supply separately. NOTE! The power supply must always be ordered separately. The light is dimmable with the LIMENTE SMART CLASSIC, LUXUS, and GREENLINE series (24 V dimmer no. 640540 and wireless wall switches no. 640541, 640542, 640543, 640544, 640546, and 640547 for control). The dimmer is installed between the power supply and the lights and has matching connectors to the power supply. Up to six LIMENTE lights can be connected to the dimmer, provided the maximum load (W) of the power supply is not exceeded. The light is also dimmable with a DALI power supply (LEDDALI100). This power supply is controlled either by a 240 V DALI dimmer or a push-button switch using the "Push Dim" function. Installation of the LIMENTE RIBBON IP44 strip is quick and easy. The power supply cable, often hidden behind cabinets, is pre-positioned so that the male end is near the power supply and the female end is near the RIBBON light strip. Remove the protective film from the light strip and press it firmly into place. Finally, connect the power supply cable to the light strip and power supply using quick-connectors. The RIBBON strip can be cut every 3.3 cm and has power supply connections on both ends, allowing both ends to be used separately if needed. The RIBBON must always be mounted on a heat-conductive material, such as the optional LED lighting bar. This product description is an automated translation of the original Finnish description.