
Roll over image to zoom in
CONNECTION CABLE LK 525 1m WITH MOLEX-CONNECTOR
LK 525 MultiZone 3V Molex cable, 1 m is a connection cable equipped with a Molex connector for LK 525 MultiZone 3V motors with Molex connections.
LK 525 MultiZone 3V is a motorized 3-way on/off control valve. The valve features a rotating slide, allowing it to withstand higher pressure differentials and reducing the risk of sticking during long periods of inactivity. This makes it particularly suitable for heat pump applications where long pauses may occur between slide movements during the warm season. A status light on the top of the motor indicates which port is open.
When a plastic adapter 066177 is installed between the valve body and the motor, the motor is protected against condensation water, frost, and high temperatures. The valve must not be installed with the motor positioned below the valve body.
In the event of a power failure, the valve slide stops in its current position. In the de-energized state, the valve slide can be manually set to the center position, which divides the flow between the heating and domestic hot water circuits. Disconnect the motor and rotate the slide approximately 30°, or until warm water flows through both ports of the valve. Upon restoration of power, the valve slide is rotated back to its original position and the motor is reinstalled.
Note that the motor can only be installed on the valve in one specific orientation. The valve body is maintenance-free. Regularly check the wiring connections.
Technical data (valve)- Operating temperature: min. 5 °C / max. 80 °C (short-term up to 90 °C)
- Ambient temperature: min. 1 °C / max. 60 °C
- Rotation angle: 60°/360°
- Leakage: < 0.1 % of Kvs at 100 kPa
- Fluid: Water – glycol max. 50 % / ethanol max. 30 %
- Maximum allowable operating pressure: 1.0 MPa (10 bar)
- Maximum pressure differential: 100 kPa (1 bar)
- Valve seat material: Brass EN 12165 CW617N
- Outer casing material: Brass EN 12164 CW614N
- Slide/axle material: PPS composite
- Ambient temperature: min. 1 °C / max. 60 °C
- Supply voltage: 230 VAC, 50 Hz
- Power: 7 VA
- Actuation time: 8 seconds (60°)
- Electrical connection: Molex® compatible connector, 6-pin
- Signal connector: Single-pole SPST
- Wire colors: Blue, brown, black
- Sheath: PVC
- Enclosure rating: IP 40
- Type approval: CE
- Connection cable: 3 x 0.75 mm²
- Cable length: 1000 mm