TAPPING ANCHOR-PLUG AISI3 M10 AISI 316

Pre-installed anchor LAH A4 acid-resistant impact anchor without flange with internal thread M10. Impact anchors are suitable for installations such as sprinkler and suspension systems. The anchor body and cone part made of acid-resistant A4 steel form a complete assembly with a suitable fastening element that withstands high loads and corrosion stress. The strength class of the HST steel component (screw, bolt, rod) used with the impact anchor is A4-50. Recommended for indoor, outdoor, and industrial use. Installation steps: 1. Drill a hole according to the product specifications. 2. Clean the hole with a wire brush and air pump. 3. Insert the anchor into the hole and expand it using the LT+ 10 impact tool by striking until the tool's shoulder is flush with the anchor surface. 4. Attach the component to be fastened with a suitable M10 bolt or threaded rod, etc., and observe the maximum tightening torque when tightening the component. When expanded, the anchor spreads against the hole walls, and the resulting friction securely holds the anchor in place. It must be noted that the anchor must always be expanded separately with an impact tool before any fastenings are made to it. The nominal size of the anchor is marked on the anchor body. Anchor length 40 mm. Packaging size: 50 pcs. Impact anchor type designation: compatible thread (M) and nominal anchor size. Internal thread length 18 mm. Suitable fastening substrates: concrete and natural stone. Suitable for fastening into non-cracked concrete. Drill hole diameter 12 mm. Drill hole depth 42 mm. The required length of the fastening element is selected on a case-by-case basis based on the thickness of the material to be fastened. This product description is an automated translation of the original Finnish description.