VIBRATION DAMPER ENTRADE SPRING 2+2 PCS/BAG

Using vibration isolator springs, noise and vibrations from air-source heat pumps and air-to-water heat pumps can be effectively controlled. The Entrade vibration isolator spring set offers exceptional damping performance and is suitable for all types of heat pumps. Steel springs are compatible with all ground, wall, and base mounting frames and provide significantly better vibration damping than traditional rubber mounts.

Features and Installation

• Load capacity of 70 kg
• Includes two softer springs SP770-05 and two harder springs SP770-06
• Harder springs are installed on the heavier side of the outdoor unit, while softer springs are installed on the lighter side
• Includes mounting bolts and washers
• Spring dimensions when unloaded: height approximately 63 mm and diameter 43 mm

Commonly used vibration isolator rubber mounts tend to harden, especially in freezing conditions, causing outdoor unit vibrations and resonant noises to transmit too strongly through building structures into interior spaces. Since springs do not harden in cold weather, their damping performance remains consistent regardless of conditions. The vibration isolator spring set can also be retrofitted in place of rubber mounts.

If the outdoor unit is very heavy, the compressor end may sag slightly more than the lighter end. The unit's alignment can be corrected by adding extra washers to the heavier end.

This product description is an automated translation of the original Finnish description.