Roll over image to zoom in
PLASTIC PADDING 180ML CHEMICAL METAL
- Two-component polyester filler
- Repairs cracks and holes in metal, concrete, and stone
- Color: dark gray
- Easy to shape, cut, and sand
- Forms a tight, strong, and extremely hard surface
- Can be drilled, threaded, and painted
- Heat resistant, withstands hot surfaces up to 190°C
- Cures in 20 minutes at +20°C
- Pack size: 180 ml
INSTRUCTIONS FOR USE
Preparation: Sand the repair surface thoroughly to remove rust and paint. Recommended sandpaper grit: 80–120.
Dispensing: Mix a golf ball-sized piece of filler (40 ml) with 3–4 cm of hardener (approximately 2–4%). Mix thoroughly until a homogeneous mass without air bubbles is achieved. Wear protective gloves and safety glasses!
Immediately close the filler and hardener containers after dispensing to prevent drying.
Application: Use a steel spatula. Spread the filler so that the compound penetrates the sanded area. Then immediately fill to the desired thickness. Once cured, sand with sandpaper of grit 80–120. Optimal application temperature: +20°C.
Curing time: Approximately 20–36 minutes at +20°C.
Cleaning: Clean tools with ethyl acetate or cellulose thinner.
This product description is an automated translation of the original Finnish description.