THERMOSTAT ROTH FOR HEATING CABLE

The thermostat is used with Roth MultiPex pipes when a self-regulating heating cable has been installed for freeze protection. The thermostat helps maintain a consistent water temperature and eliminates unnecessary system operation. The temperature is adjusted by turning the potentiometer inside the thermostat. The external sensor is placed inside the protective pipe. The thermostat ensures that the water does not heat above the set temperature (recommended 6 degrees). Additional information is provided in the attached data sheet. The Roth MultiPex pipe with an 11 W self-regulating heating cable is intended for installations requiring the maintenance of hot and heating water systems in frost-prone conditions. The self-regulating heating cable is bonded to the MultiPex pipe to ensure direct contact and optimal heat transfer. The MultiPex pipe is supplied within a Roth protective pipe (28 or 34 mm), which protects both the MultiPex pipe and the heating cable. The protective pipe is covered with a 20 mm Roth X-Plus insulation sleeve, providing optimal insulation for installations. The self-regulating heating cable is delivered fully assembled and equipped with a plug. This allows the installer to focus on the plumbing installation and simply connect the heating cable to a 230V socket. The cable may be shortened if necessary, but electrical work must be performed only by a licensed electrician. This also applies to the installation of the thermostat with an external sensor. Installation instructions for the thermostat are included with the thermostat. Applications: Direct freeze protection for water supply installations in homes, cottages, and other buildings at risk of freezing. This type of pipe is also commonly used for temporary installations. The heating cable can be disconnected and used as needed. This product description is an automated translation of the original Finnish description.