ANCHOR SORMAT S-KA+ 12X88/10/- ZINC PLATED 2PCS

High-quality Finnish-made updated Sormat S-KA+ electroplated M12 wedge anchor. Premium domestic torque-controlled wedge anchors are suitable for pre-installation, through-installation, and remote installation. The anchor body, manufactured from carbon steel through cold working, is durable and safe, effectively withstanding loads applied to the fastening. Surface treatment is electroplating (? 5 µm) according to EN ISO 4042, followed by Cr3+ compliant passivation. Recommended operating environment: dry indoor areas. The product has European Technical Approval ETA-16/0934 for fastenings in concrete (Option 1). The product is also CE marked. The product is classified as fire resistant up to R120 in concrete installations. Installation steps: 1. Drill a hole according to product specifications. 2. Clean the hole with a wire brush and air pump. Cleaning: brush x 2, pump x 2, brush x 2. 3. Drive the anchor into place with a hammer or mechanically using an installation tool. 4. Tighten the anchor to the specified torque value using a torque wrench. During tightening, the anchor wings expand against the hole walls, and the resulting friction securely holds the anchor in place. The anchor size and thickness of the attached component are marked on the anchor body. A length marking identifier D is located at the end of the anchor body. Packaging size: 2 pcs. Packaging type: small pack. Wedge anchor type designation: nominal diameter x length / fastening thickness. Thread length 38 mm. Spanner size AV19. Suitable substrates: concrete and natural stone. Suitable for fastenings in both cracked and uncracked concrete. Drill hole diameter 12 mm. Drill hole depth 70 mm. Thickness of attached material 10 mm. This product description is an automated translation of the original Finnish description.