DROP IN ANCHOR SORMAT JE+ M10 STAINLESS STEEL A4 50PCS

Pre-installed, acid-resistant Sormat JE+ A4 impact anchor without flange (internal thread M10). Impact anchors are suitable for installations such as sprinkler and suspension systems. The anchor body and cone made of acid-resistant A4 steel form a complete assembly with a suitable fastening element that effectively withstands applied loads and corrosion stress. Features

• Strength class of HST steel component (screw, bolt, rod) used with impact anchor: A4-50
• Recommended environment: indoor, outdoor, and industrial use
• European Technical Approval ETA-22/0912 for non-structural anchorages in concrete
• CE marked.
• Fire classification up to R120 in concrete installations
• Anchor length 40 mm
• Pack size 50 pcs
• Impact anchor type designation: suitable thread (M) and nominal anchor size
• Internal thread length 17 mm
• Compatible substrates: concrete and natural stone
• Suitable for fastening in both cracked and uncracked concrete
• Drill hole diameter 12 mm
• Drill hole depth 43 mm

The required length of the fastening element is selected on a case-by-case basis according to the thickness of the material to be fastened.

Installation steps

1. Drill a hole according to the product specifications.

2. Clean the hole with a wire brush and/or air pump.

3. Insert the anchor into the hole and expand it using an impact tool by striking M10 until the tool's shoulder is flush with the anchor surface.

4. Attach the component to be fastened with a suitable M10 bolt or threaded rod, etc., and observe the maximum tightening torque when tightening the component.

When expanded, the anchor spreads against the hole walls, and the resulting friction securely holds the anchor in place. It must be noted that the anchor must always be expanded separately with an impact tool before any fastenings are made to it. The nominal anchor size is marked on the anchor body.

This product description is an automated translation of the original Finnish description.