DROP IN ANCHOR SORMAT JE+ M6 STAINLESS STEEL A4 100PCS

Pre-installed, acid-resistant Sormat JE+ A4 impact anchor without flange (internal thread M6). Impact anchors are suitable for installations in sprinkler and suspension systems. The anchor body and cone made of acid-resistant A4 steel form a complete assembly with a suitable fastening element that withstands high loads and corrosion stress well. Features

• Strength class of HST steel component (screw, bolt, rod) used with impact anchor: A4-50
• Recommended environment: indoor, outdoor, and industrial use
• European Technical Approval ETA-22/0912 for non-structural anchor applications in concrete
• CE marked
• Fire classification up to R120 in concrete installations
• Anchor length 25 mm
• Pack size 100 pcs
• Impact anchor type designation: compatible thread (M) and nominal anchor size
• Internal thread length 10 mm
• Compatible substrates: concrete, natural stone, and solid brick
• Suitable for installation in both cracked and uncracked concrete
• Drill hole diameter 8 mm
• Drill hole depth 27 mm

The required length of the fastening element is selected on a case-by-case basis according to the thickness of the material to be fastened.

Installation steps

1. Drill a hole according to the product specifications.

2. Clean the hole with a wire brush and/or air pump.

3. Insert the anchor into the hole and expand it using an impact tool by striking with M6 until the tool's shoulder is flush with the anchor surface.

4. Attach the component to be fastened with a suitable M6 bolt or threaded rod, etc., and observe the maximum tightening torque when tightening the component.

When expanded, the anchor spreads against the hole walls, and the resulting friction securely holds the anchor in place. It must be noted that the anchor must always be expanded separately with an impact tool before any fastenings are made to it. The nominal anchor size is marked on the anchor body.

This product description is an automated translation of the original Finnish description.