Roll over image to zoom in
TAPPING CONNECTOR 1x6(10)mm2/6x1.5(2,5)mm2 BLUE
- suitable for collecting neutral conductors of fault currents
- input side: 1 x 6 (10) mm² / output side: 6 x 1.5 (2.5) mm²
- integrated terminal plate
- terminal width of 9 mm, i.e. 1/2 module
- for DIN rail 35
With WAGO TOP JOB branch connectors, you collect the neutral conductors of fault currents into a single connector, and install phase separation or low-voltage side +/- isolation using WAGO's new branch connectors, also referred to as collector connectors.
There are four color variants: blue, gray, black, and red. The input side has one terminal for a maximum conductor cross-section of 10 mm², and the output side has six terminals for a maximum conductor cross-section of 2.5 mm². The connectors are easy to install thanks to the push-in spring technology and feature a fixed terminal plate. Using these connectors saves space on the side because the connector width is only 9 mm, i.e., 1/2 module. Labeling can be done traditionally with WMB labels or printed using a Smartprinter.
Two-terminal connectors can be bridged to the same potential using two bridges (2001-404, No. 1923103), and three-terminal connectors can be bridged to the same potential using two bridges (2001-406, No. 1927408). Double bridging must be used for current-carrying capacity.
This product description is an automated translation of the original Finnish description.