WATEWATER PUMPSTATION WILO DRAINLIFT SANI CUT-S.20M/1

Compact, pre-assembled and fully submerged constant pump station with a shredder hydraulic system for pumping pressurized wastewater. Gas- and water-tight collection tank with a sloped bottom and an inspection opening equipped with a transparent lid. Freely selectable inlet flows within marked areas. Level measurement implemented via an analog output signal using a float switch and two switching points. Pressure connection with a check valve attached. Surface-cooled motor with thermal motor monitoring. Pre-installed control unit for automatic operation:

• General alarm with potential-free contact
• Integrated and mains voltage-independent alarm
• Adjustable run-on time
• 1.5 m connection cable with plug

Delivery contents

• Fully submerged pump station with shredder, control unit and plug-in connection cable
• Pipe connection DN 32 (outer diameter 40 mm)
• HT double coupling DN 40 (50 mm) for air vent connection
• HT double coupling DN 40 (50 mm) for drainage connection
• Inlet flow set with hole saw 124 mm (5") and seal DN 100 (110 mm)
• Floor mounting set
• Sound insulation mat
• 9 V rechargeable battery
• Installation and operating instructions

This product description is an automated translation of the original Finnish description.