REPEATER FRP70-230V WIRELESS

1- and 2-level wireless amplifier with a small antenna, installation e.g. in a suspended ceiling.

If needed, the wireless antenna FA250 (part no. 2814015) can be connected to the amplifier.

Standby power consumption is only 0.6 watts. Supply voltage 230V. The housing is removable to allow connection of a 2-wire mains cable (e.g. a cord with a European plug). Choose the highest possible location for the antenna for optimal operation, e.g. in a suspended ceiling.

This amplifier is only required if building conditions, such as thick stone walls, metal, etc., prevent uninterrupted wireless signal transmission or if the distance between the wireless button and receiver is too long. Instead of the supplied antenna, it is possible to connect antenna FA250 with a 250 cm cable or FAG55E with a 100 cm cable.

By placing the amplifier in an optimal location, the reception range can be significantly extended. By default, the 1-level amplifier is activated. Only signals from wireless buttons/sensors are received, tested, and retransmitted at full transmission power. Signals from other amplifiers are ignored to limit data volume.

Use the rotary switch to switch to 2-level mode. In this mode, wireless signals from sensors and from another 1-level amplifier are repeated. Therefore, the signal can be received and amplified twice: from the 1-level amplifier to the 2-level amplifier. The LED indicator flashes briefly whenever a wireless signal is received. No other wireless amplifiers need to be programmed into the device. They receive and amplify signals from all wireless transmitters within their reception range.

This product description is an automated translation of the original Finnish description.