Roll over image to zoom in
DIMMER WIRELESS FLC61NP-230V
ES (V) + TLZ: In this mode, the normal impulse relay function with buttons is active. With the lower rotary switch, you can select the RV deactivation delay for ESV function between 0-60 minutes. Turn on/off by pressing the general button (on the same side as the on/off button) or the direction button (on the opposite side of the on/off button). The step-light automation function TLZ is activated via the Central ON button and a timer set by the RV rotary switch.
AUTO1: In AUTO1 mode (semi-automatic motion: deactivation only via motion sensor), on/off control is performed via the general buttons (on the same side as the on/off button), direction buttons (on the opposite side of the on/off button), or central control buttons. Deactivation occurs via one or more wireless motion sensors when no motion is detected after the RV time delay set by the lower rotary switch (0–60 minutes).
AUTO2: In AUTO2 mode (semi-automatic motion and brightness: deactivation only via motion/brightness sensor), on/off control is performed via the general buttons (on the same side as the on/off button), direction buttons (on the opposite side of the on/off button), or central control buttons. Deactivation occurs via one or more wireless motion sensors/dimmer switches when no motion is detected or brightness is insufficient after the RV time delay set by the lower rotary switch (0–60 minutes).
AUTO3: In AUTO3 mode (fully automatic motion: on/off controlled by motion), activation occurs when the brightness threshold is exceeded using one or more wireless motion sensors/dimmer switches. Deactivation occurs when no motion is detected after the RV time delay set by the lower rotary switch (0–60 minutes). Additionally, on/off control is performed via the general buttons (on the same side as the on/off button), direction buttons (on the opposite side of the on/off button), or central control buttons.
AUTO4: In AUTO4 mode (fully automatic motion and brightness: on/off controlled by motion and brightness), activation occurs when the brightness threshold is exceeded using one or more wireless motion sensors/dimmer switches, and deactivation occurs when no motion is detected or brightness is sufficient, with the delay set between 0–60 minutes using the lower rotary switch RV. Additionally, on/off control is performed via the general buttons (on the same side as the on/off button), direction buttons (on the opposite side of the on/off button), or central control buttons.
- 1 normally open (NO), non-potential-free contact 10A/250V AC.
- 230V LED load up to 400W, incandescent lamp load up to 2000W.
- Standby power consumption only 0.8 watts
- Recessed mounting, length 45mm, width 45mm, depth 33mm.