DALI GATEWAY FD2G14

RS485 bus to DALI2 bus converter (gateway). DALI-2 certified. DALI-2 is the latest generation of the DALI standard, offering an expanded range of functions. DALI-2 devices also include all previous DALI functions and are therefore backward compatible with older devices. Modular unit designed for DIN-rail mounting according to standard DIN-EN 60715 TH35. 2 modules = width 36mm, depth 58mm. Connection to Eltakon RS485 bus. Bus and power supply are connected via jumpers. Use only with FAM14. Supply voltage 230V/50Hz to terminals L and N. DALI device voltage according to IEC 62386 at DA +/- terminals. Output current 200mA / max. 250mA. Turn-on time max. 250ms. In case of a short circuit, the power supply cuts off the supply voltage. A mechanism for cyclic reconnection attempts is available. With the FD2G14 gateway, DALI devices can be controlled via signals from wireless EnOcean devices. Groups 0-15 can be controlled and broadcast commands can be sent. Additionally, DALI scenarios/states 0-15 can be controlled. DALI installations controlled solely by FD2G14 must be assigned to groups 0-15. Evaluation of DALI-2 sensors can be configured and activated via the PCT14 software. DALI-2 event messages can be interpreted and transmitted out via the RS485 bus using the device's Hold terminal. This enables transmission of data to the wireless EnOcean radio frequency network via FTD14. FD2G14 reserves 16 device addresses from the 14-series. Device address messages correspond to dimming values in DALI groups 0-15 in ascending order. Status information can be read via the PCT14 software for each individual group, such as dimming value (%) and button messages (ON/OFF). Status information can then be used to control 14-series actuators. The FD2G14 device operates as a master and includes power supply for the DALI bus. With the rotary switch, buttons can only be assigned to groups 0-8 and DALI scenarios/states 0-9. Activation messages from groups 9-15 and scenarios 10-15 can only be performed via the PCT14 software. Starting from production week 30/19, FD2G14 can be used as a single-channel device 'FD2G14-Broadcast'. This is set when the device address is assigned. Important: Wireless buttons must always be double-clicked when manually learning them into FD2G14. CLR (clear function) requires only one press. A direction button or universal button with the same ID can be assigned multiple times to different groups. The last selected group is always active, so the button can only switch one group or send a "broadcast" message to all groups. One FBH per group can also be learned. With manual learning, this always works regardless of brightness. With PCT14, you can also set the brightness threshold. The turn-off delay when no motion is detected can be set in minutes (1...60) for all FBH devices in all groups. Default value is 3 minutes. This product description is an automated translation of the original Finnish description.