MOTION DETECTOR KNX 180° 1.1M COMF. WHITE ROUND

KNX motion detector module for flush mounting with a round mounting ring, integrated temperature sensor, and integrated bus coupling unit Operating voltage via bus 21 ... 32 VDC Power consumption KNX max. 10 mA Default mounting height 2.2 m Delay time adjustable 10 s ... 30 min Response illuminance adjustable ~ 5 ... 1000 lx, ∞ lx (day) Detection area rectangular ~ 12 x 16 m Operating temperature -5 ... +45 °C Automatic bus operation triggered by motion in the detection area or manual control via integrated button. Continuous direct sunlight pointing towards the detection surface may cause malfunction of the motion detector. Suitable for indoor use only! - Button for automatic/permanent ON/permanent OFF - 3 operating modes: automatic/permanent ON/permanent OFF - Controller/jack operation for covering large detection areas - Test mode - Operating mode display via status LED: red/green/orange - Definition of controller mode - Integrated temperature sensor for transmitting measured values via object - Integrated button can be configured for manual control of bus functions - Button functions: switching, dimming, shutter, value transmitter, status, priority - Two operating channels for illuminance-dependent functions - Additional channel for illuminance-independent detection mode - Illuminance value transmission possible via object - Integrated bus coupling unit - Bus connection via plug-in connector - Mounting clips - Removal protection Suitable for use with R.classic cover plates. When using the motion detector with the Series 1930, separate cover plates with a 58 mm central opening must be used. Combined mounting with Series 1930 is not possible. This product description is an automated translation of the original Finnish description.