PIR-RÖRELSESENSOR 360 CSEZ-01/13

The zconventionalz PIR presence indicator with relay output records movements indoors using the PIR-2xDual element sensor. This can be used for, e.g.: switching lighting systems as well as for requesting the heating or air conditioning when persons are in the room (make the correct settings!). as the brightness (approx. 2 - 2000 lux) when the PIR presence indicator is activated as well as the off-delay (approx. 10 seconds 5 minutes) can be set via a potentiometer under the device cover. Using jumpers (also under the device cover), a pre-warning buzzer that can be heard for approx. 5 seconds before switching off is activated. An LED indicates if the relay output is activated. The device is mains-supplied, the relay contact is potential-free. in order to integrate the PIR movement sensor into the Eaton radio system, the evaluation of the signal can each be carried out in mode 2 via the binary input 230x265626VAC (2) or binary input 265627xSignalkontakt (2). The mounting is carried out in a built-in ceiling installation box using a screw claw or screw fixing located on the device. Notice: observe the correct wiring!